Keysight Technologies 33210A - Page 302

5 Error Messages
302 Keysight 33210A User’s Guide
-221
Settings conflict;
PWM turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst mode to
be enabled at the same time. When you enable a modulation, sweep, or burst
mode, all other modes are turned off.
-221
Settings conflict;
sweep turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst mode to
be enabled at the same time. When you enable a modulation, sweep, or burst
mode, all other modes are turned off.
-221
Settings conflict;
not able to modulate this function
The function generator cannot generate an AM or FM modulated waveform using
the ramp, pulse, noise, dc voltage, or arbitrary waveform functions.
-221
Settings conflict;
PWM available in only pulse function
The function generator cannot generate a PWM modulated waveform using any
function other than pulse.
-221
Settings conflict;
not able to sweep this function
The function generator cannot generate a sweep using the pulse, noise, dc
voltage, or arbitrary waveform functions.