Keysight Technologies 33210A - Page 303

Error Messages 5
Keysight 33210A User’s Guide 303
-221
Settings conflict;
not able to burst this function
The function generator cannot generate a burst using the pulse, noise, dc voltage,
or arbitrary waveform functions.
-221
Settings conflict;
not able to modulate noise, modulation turned off
The function generator cannot generate a modulated waveform using the noise
function. The selected modulation mode has been turned off.
-221
Settings conflict;
not able to modulate arb waveforms, modulation turned off
The function generator cannot generate a modulated waveform using the
arbitrary waveform function. The selected modulation mode has been turned off.
-221
Settings conflict;
not able to modulate ramp waveforms, modulation turned off
The function generator cannot generate a modulated waveform using the ramp
function. The selected modulation mode has been turned off.
-221
Settings conflict;
not able to sweep pulse, sweep turned off
The function generator cannot generate a sweep using the pulse function. The
sweep mode has been turned off.
-221
Settings conflict;
not able to modulate dc, modulation turned off
The function generator cannot generate a modulated waveform using the
dc voltage function. The selected modulation mode has been turned off.