Keysight 81160A - Page 532

Appendix
532
Command
:ARM:SLOP[1|2][?]
Long
:ARM[:SEQuence[1]|STARt][:LAYer[1]]:SLOPe[1|2][?]
Parameters
{POSitive|NEGative|EITHer}
Parameter Suffix

Description
Use this command to select the trigger slope for the triggering signal when
triggering on edges. Select EITHer to trigger on both the positive and
negative edge of the triggering signal. To select the external input as trigger
source use :ARM:SOUR[1|2] EXT or gating level.
Example
:ARM:SLOP1 POS