8 General Programming
252 M8190A User’s Guide
8.20.2 [:SOURce]:SEQuence[1|2]:DATA[?]
<sequence_id>,<step>[,<length>|,<value>,<value>…|,<data block>]
<length> number of sequence table entries.
This command defines a new sequence. The <length> parameter specifies the
number of sequence table entries in the sequence.
The new <sequence-id> in the range 0…512K–2 is returned. This value is the index of
the first sequence table entry of this sequence.
This SCPI has the following syntax for command/query:
Command
[:SOURce]:SEQuence[1|2]:DATA <sequence_id>,<step>,[<value>,<value>,…|<data
block>]
Query
[:SOURce]:SEQuence[1|2]:DATA? <sequence_id>,<step>,<length>