Keysight M8190A - Arm[:Sequence][:Start][:Layer]:Rnoisefloor[1|2 OFF|ON|0|1

General Programming 8
M8190A User’s Guide 199
8.8.4 :ARM[:SEQuence][:STARt][:LAYer]:RNOisefloor[1|2][?] OFF|ON|0|1
Command
:ARM:RNO[?]
Long
:ARM:RNOisefloor[?]
Parameters
OFF|ON|0|1
Parameter Suffix
None
Description
Set or query the state of the “Reduced Noise Floor” feature.
0/OFF – Noise reduction disabled.
1/ON – Noise reduction enabled.
If the noise reduction is enabled, coarse and fine delay are constant and cannot be
adjusted.
Example
Command
:ARM:RNO ON
Query
:ARM:RNO?
8.8.5 :INITiate:CONTinuous[1|2]:ENABle[?] SELF|ARMed
Command
:INIT:CONT[1|2]:ENAB[?]
Long
:INITiate:CONTinuous[1|2]:ENABle[?]
Parameters
SELF|ARMed
Parameter Suffix
None