Keysight M8190A - 8.26:ATABle Subsystem

General Programming 8
M8190A User’s Guide 305
8.25.2 [:SOURce]:FTABle[1|2]:RESet
Command
:FTAB:RES
Long
:FTABle:RESet
Parameters
None
Parameter Suffix
None
Description
Reset all frequency table entries to default values.
Example
Command
:FTAB:RES
8.26 :ATABle Subsystem
The ATABle (Amplitude Table) subsystem is available in interpolated modes. It offers
the following functionality:
 Definition of up to 32K amplitude scale values that can afterwards be used to
scale the amplitudes for the I/Q data segments referenced from sequence table
entries.
 Range: [0.0, 1.0]
Changes to the amplitude table are only possible while the corresponding channel is
idle, i.e. not armed and not generating a waveform
8.26.1 [:SOURce]:ATABle[1|2]:DATA[?] <amplitude_table_index>,
(<length>|<block>|<amplitude_scale>,<amplitude_scale>…)
Command
:ATAB:DATA[?]
Long
:ATABle:DATA[?]