Keysight M8190A - Trace[1|2]:Count[?] <Count

8 General Programming
296 M8190A User’s Guide
8.22.23 :TRACe[1|2]:COUNt[?] <count>
Command
:TRAC:COUN[?]
Long
:TRACe:COUNt[?]
Parameters
<count>
Parameter Suffix
None
Description
Use this command or query to set or get the segment loop count for the selected
segment. The segment loop count is used, if the segment is played in arbitrary mode.
<count> – 1..4G-1: number of times the selected segment is repeated.
Example
Command
:TRAC:COUN 1
Query
:TRAC:COUN?
8.22.24 :TRACe[1|2]:MARKer[:STATe][?] OFF|ON|0|1
Command
:TRAC:MARK[?]
Long
:TRACe:MARKer[?]
Parameters
OFF | ON | 0 | 1
Parameter Suffix
None
Description
Use this command to enable or disable markers for the selected segment. The query
form gets the current marker state.