Keysight M8190A - Source]:DC[1|2]:Voltage[:Level][:Immediate]:Termination Level

General Programming 8
M8190A User’s Guide 241
Description
Set or query the output low level.
Example
Command
:DAC:VOLT:LOW -0.3
Query
:DAC:VOLT:LOW?
8.16.7 [:SOURce]:DC[1|2]:VOLTage[:LEVel][:IMMediate]:TERMination[?] <level>
Command
:DC:VOLT:TERM[?]
Long
:DC:VOLTage:TERMination[?]
Parameters
<level>
Parameter Suffix
None
Description
Set or query the termination voltage level.
Example
Command
:DC:VOLT:TERM 3e-1
Query
:DC:VOLT:TERM?
8.17 :VOLTage Subsystem
Set the voltages for the currently selected output path (DAC, DC, or AC; selected
with the OUTP:ROUT:SEL command).