Keysight M8190A - Source]:Stable[1|2]:Dynamic:hwdisable[:State OFF|ON|0|1

8 General Programming
266 M8190A User’s Guide
8.21.7 [:SOURce]:STABle[1|2]:DYNamic:HWDisable[:STATe][?] OFF|ON|0|1
Command
:STAB:DYN:HWD[?]
Long
:STABle:DYNamic:HWDisable [?]
Parameters
OFF | ON | 0 | 1
Parameter Suffix
None
Description
Set or query the dynamic port hardware input disable state. The command has only
an effect when the dynamic mode for segments or sequences is active. When the
hardware input is disabled, segments or sequences can only be selected dynamically
using the [SOURce]:STABle:DYNamic:SELect < sequence-table-index> command.
When the hardware input is enabled, segments or sequences can be selected
dynamically by command or by the signal present at the dynamic control port.
Example
Command
:STAB:DYN:HWD 1
Query
:STAB:DYN:HWD?
8.21.8 [:SOURce]:STABle[1|2]:SEQuence:SELect[?] <sequence_table_index>
Command
:STAB:SEQ:SEL[?]
Long
:STABle:SEQuence:SELect[?]
Parameters
<sequence_table_index>
Parameter Suffix
None
Description
Select where in the sequence table the sequence starts in STSequence mode. In
dynamic sequence selection mode select the sequence that is played before the first
sequence is dynamically selected.