Keysight M8190A - Trigger[:Sequence][:Start]:Enable[1|2]:Hwdisable[:State 0|1|OFF|ON

General Programming 8
M8190A User’s Guide 209
Description
Set or query the source for the enable event.
TRIGger - trigger input
EVENt - event input
Example
Command
:TRIG:SOUR:ENAB TRIG
Query
:TRIG:SOUR:ENAB?
8.8.19 :TRIGger[:SEQuence][:STARt]:ENABle[1|2]:HWDisable[:STATe][?]
0|1|OFF|ON
Command
:TRIG:ENAB:HWD[?]
Long
:TRIGger:ENABle:HWDisable[?]
Parameters
0|1|OFF|ON
Parameter Suffix
None
Description
Set or query the hardware input disable state for the enable function. When the
hardware input is disabled, an enable event can only be generated using the
:TRIGger[:SEQuence][:STARt]:ENABle[1|2][:IMMediate] command. When the
hardware input is enabled, an enable event can be generated by command or by a
signal present at the trigger or event input.
Example
Command
:TRIG:ENAB:HWD ON
Query
:TRIG:ENAB:HWD?