Keysight M8190A - Initiate:immediate[1|2]

General Programming 8
M8190A User’s Guide 201
Parameters
OFF | ON | 0 | 1
Parameter Suffix
None
Description
Set or query the gate mode. This command must be used together with
INIT:CONT[1|2] to set the trigger mode.
0/OFF – Gate mode is off.
1/ON – Gate mode is on. If continuous mode is off, the trigger mode is “gated”.
Example
Command
:INIT:GATE:STAT ON
Query
:INIT:GATE:STAT?
Table 8-12: Trigger Mode Settings
INIT:CONT
INIT:GATE
Trigger Mode
0
0
Triggered
0
1
Gated
1
0
Continuous
1
1
Continuous
8.8.8 :INITiate:IMMediate[1|2]
Command
:INIT:IMM[1|2]
Long
:INITiate:IMMediate[1|2]
Parameters
None
Parameter Suffix
None
Description
Start signal generation on a channel. If channels are coupled, both channels are
started.
Example
Command
:INIT:IMM