Keysight M8190A - The Front Panel of the One Channel Instrument

Introduction 1
M8190A User’s Guide 23
1.4 The Front Panel of the One Channel Instrument
The Front Panel of the one channel M8190A is shown in the figure below.
Figure 1-2: Front Panel of M8190A (1 Channel)
Inputs/Outputs
The description of the inputs and outputs of is given in the section Inputs/Outputs.
The 1 channel M8190A has following differences compared to the 2 channel
M8190A:
 The SAMPLE MRK OUT, DIRECT OUT and AMP OUT of channel 2 is not
available.
 The SYNC MRK OUT 2 of channel 2 is not available.
 There is one SMA connector labeled ‘Do not connect’.
 Input (SYS CLK IN) and System Clock Output (SYS CLK IN) are reserved for
future use. Do not connect!
 There is one SMA connector labeled ‘Do not connect’. This connector is for
future use.
Status LED
The functionality of the LED is identical with the 2 channel M8190A. Refer to the
section Status LED for a description of the status LED.