Keysight M8190A - Generating Scenarios

8 General Programming
260 M8190A User’s Guide
8.21.4 Generating scenarios
Set the scenario advancement mode using the STAB[1|2]:SCEN:ADV command.
Set the scenario loop count using the STAB[1|2]:SCEN:COUN command.
Select the sequence table entry that describes the first segment in your scenario
using the STAB[1|2]:SCEN:SEL command.
Select non-dynamic mode using the command STAB[1|2]:DYN OFF.
Before starting signal generation with INIT:IMM[1|2] select the scenario mode
using the FUNC:MODE STSC command.
8.21.5 [:SOURce]:STABle[1|2]:RESet
Command
:STAB:RES
Long
:STABle:RESet
Parameters
None
Parameter Suffix
None
Description
Reset all sequence table entries to default values.
Example
Command
:STAB:RES
8.21.6 [:SOURce]:STABle[1|2]:DATA[?]
<sequence_table_index>,(<length>|<block>|<value>,<value>…)
Command
:STAB:DATA[?]
Long
:STABle:DATA[?]
Parameters
<sequence_table_index>,(<length>|<block>|<value>,<value>…)
Parameter Suffix
None