Keysight M8190A - 8.16:DAC|DC|AC Subsystem

8 General Programming
238 M8190A User’s Guide
8.16 :DAC|DC|AC Subsystem
Set or query voltages or format for the different output paths (DAC, DC, AC selected
with the OUTP:ROUT:SEL command).
8.16.1 [:SOURce]:DAC|DC|AC[1|2]:FORMat[?] RZ|DNRZ|NRZ|DOUBlet
Command
:DAC|DC|AC:FORM[?]
Long
:DAC|DC|AC:FORMat[?]
Parameters
RZ|DNRZ|NRZ|DOUBlet
Parameter Suffix
None
Description
Set or query the DAC format mode.
Example
Command
:DAC:FORM DNRZ
:DC:FORM NRZ
:AC:FORM RZ
Query
:DAC:FORM?
:DC:FORM?
:AC:FORM?
DAC Format Modes
For further details, refer to the section NRZ / DNRZ / Doublet.
8.16.2 Voltage Ranges
Formulae
High Level = Offset + Amplitude / 2
Low Level = Offset – Amplitude / 2
Ranges
The table below shows absolute voltage limits. Effective values may depend on the
route’s current other levels.
All values are given in V.