Keysight M8190A - Qonly|Both,On|Off|1|0,[,Alength|Fill|[,<Init_Valuei Init_Valueq> [,<Ignore_Header_Parameters>]]

8 General Programming
282 M8190A User’s Guide
This SCPI has the following syntax for command/query:
Command
:TRACe[1|2][:DATA] <segment_id>,<offset>,(<block>|<numeric_values>)
Query
:TRACe[1|2][:DATA][?] <segment_id>,<offset>,<length>
Example
Command
Load data consisting of 480 samples as comma-separated list into previously defined
segment 1 starting at sample offset 0.
:TRAC1:DATA 1,0,0,1,2,…,479
Query
:TRAC:DATA? 1,0,48
8.22.13 :TRACe[1|2]:IQIMport <segment_id>,<file_name>,TXT|TXT14|BIN|IQBIN|
BIN6030|BIN5110|LICensed|MAT89600|DSA90000|CSV,IONLy|QONLy|BOTH,ON|O
FF|1|0,[,ALENgth|FILL|[,<init_valueI>[,<init_valueQ>
[,<ignore_header_parameters>]]
Command
:TRAC:IQIM
Long
:TRACe:IQIMport
Parameters
segment_id>,
<file_name>,
TXT|TXT14|BIN|IQBIN|BIN6030|BIN5110|LICensed|MAT89600|DSA90000|CSV,
IONLy|QONLy|BOTH,
ON|OFF|1|0,
[,ALENgth|FILL|
[,<init_valueI>
[,<init_valueQ>[,
<ignore_header_parameters>]]