Keysight M8190A - Source]:Stable[1|2]:Scenario:select Sequence_Table_Index

General Programming 8
M8190A User’s Guide 269
Description
When the dynamic mode for segments or sequences is active, set or query the
selected sequence table entry.
Example
Command
:STAB:DYN:SEL 0
Query
:STAB:DYN:SEL?
8.21.12 [:SOURce]:STABle[1|2]:SCENario:SELect[?] <sequence_table_index>
Command
:STAB:SCEN:SEL[?]
Long
:STABle:SCENario:SELect[?]
Parameters
<sequence_table_index>
Parameter Suffix
None
Description
Select where in the sequence table the scenario starts in STSCenario mode.
Example
Command
:STAB:SCEN:SEL 0
Query
:STAB:SCEN:SEL?
8.21.13 [:SOURce]:STABle[1|2]:SCENario:ADVance[?] AUTO|CONDitional|REPeat|SINGle
Command
:STAB:SCEN:ADV[?]
Long
:STABle:SCENario:ADVance[?]
Parameters
AUTO | COND | REP | SING
Parameter Suffix
None