Keysight M8190A - Connection Status Subsystem

General Programming 8
M8190A User’s Guide 195
8.7.8 Connection Status Subsystem
The Connection Status register contains the state of the USB connection to the
M8190A module.
The following SCPI commands and queries are supported:
:STATus:QUEStionable:CONNection[:EVENt]?
:STATus:QUEStionable:CONNection:CONDition?
:STATus:QUEStionable:CONNection:ENABle[?]
:STATus:QUEStionable:CONNection:NTRansition[?]
:STATus:QUEStionable:CONNection:PTRansition[?]
Table 8-8: Connection Status Register
Bit Number
Decimal Value
Definition
0 USB disconnected
1
USB module connection state
8.7.9 Run Status Subsystem
The Run Status register contains the run status conditions of the individual channels.
The following SCPI commands and queries are supported:
:STATus:OPERation:RUN[:EVENt]?
:STATus:OPERation:RUN:CONDition?
:STATus:OPERation:RUN:ENABle[?]
:STATus:OPERation:RUN:NTRansition[?]
:STATus:OPERation:RUN:PTRansition[?]
Table 8-9: Run Status Register
Bit Number
Decimal Value
Definition
0 Run Status
1
Indicates if channel 1 is running (:INIT:IMM1 was executed and signals
are generated).
1 Run Status
2
Indicates if channel 2 is running (:INIT:IMM2 was executed and signals
are generated).