Keysight M8190A - Instrument:identify:stop

8 General Programming
218 M8190A User’s Guide
8.11.4 :INSTrument:IDENtify:STOP
Command
:INST:IDEN:STOP
Long
:INSTrument:IDENtify:STOP
Parameters
None
Parameter Suffix
None
Description
Stop the flashing of the green “Access” LED before the flashing interval has elapsed.
Example
Command
:INST:IDEN:STOP
8.11.5 :INSTrument:MMODule:CONFig?
Command
:INST:MMOD:CONF?
Long
:INSTrument:MMODule:CONFig?
Parameters
None
Parameter Suffix
None
Description
This query returns the state of the multi-module configuration mode (0: disabled, 1:
enabled). Some parameters are only available on the master of a multi-module group
and not on the slaves. They can only be changed on the master module when multi-
module configuration mode is enabled. The corresponding commands are:
 :TRACe[1|2]:DWIDth WSPeed|WPRecision|INTX3|INTX12|INTX24|INTX48
 [:SOURce]:FREQuency:RASTer <frequency>
 [:SOURce]:FREQuency:RASTer:EXTernal <frequency>
 [:SOURce]:FREQuency:RASTer:SOURce[1|2] INTernal|EXTernal
 [:SOURce]:ROSCillator:SOURce EXTernal|AXI|INTernal
 [:SOURce]:ROSCillator:FREQuency <frequency>|MINimum|MAXimum