Keysight M8190A - 4.3 Configuration at Run-Time

Digital Up-Conversion 4
M8190A User’s Guide 131
4.2.2 Markers in Interpolated Modes
Markers can be provided for each incoming IQ sample pair. It is not possible to
perform marking of interpolated sample values.
For more details about markers, refer to chapter Markers.
The marker to sample output delay is different in the digital up-conversion mode
compared to the corresponding value in direct modes
(see datasheet).
4.3 Configuration at Run-Time
Required Option
This section describes functionality which requires Option -SEQ.
Figure 4-2: Mechanisms to Change Configuration at Run-Time