30 Keysight Technologies N9040B UXA Signal Analyzer Service Guide
Overview
Service Equipment You Will Need
Required Test Equipment List
The following table identifies the equipment recommended for
troubleshooting, adjusting, and verifying the performance of the instrument.
Only the recommended and alternate equipment is compatible with the
performance verification testing. Some tests can use various models of a
particular equipment type. The “Recommended Keysight Model” is the
preferred equipment. However, the “Alternative Keysight Model” is an
acceptable substitute.
Table 1-1 Required Test Equipment
Instrument
Recommended Model
a
Alternative Model
a
Use
b
Signal Sources
Microwave Signal Generator #1 E8257D
(Options 567, 1EA/1EU, 1E1)
PSG
c
P, T
Microwave Signal Generator #2
(only required for Third Order
Intermodulation and Gain
Compression)
E8257D
(Option 1EA/1EU)
PSG
c
83630A/B/L (Option 001, 008),
83640A/B/L (Option 001, 008),
83650A/B/L (Option 001, 008)
P
Low Noise
Signal Generator
(one PSG may be used for
multiple sources.
See footnote
c
)
E8257D
(Options UNR, UNX, or UNY)
PSG
c
(Options UNR, UNX, or UNY)
P, T
RF Signal Generator
(one PSG may be used for
multiple sources.
See footnote
c
)
E8257D
(Options UNR, UNX, or UNY)
PSG
c
(Options UNR, UNX, or UNY)
P
Ultra Low Noise Reference
Frequency Source
(required for testing UXA Phase
Noise)
Wenzel Associates Inc
d
Ultra Low Noise Reference Frequency
Source
Model 500-13438 Rev D
P
Function Generator 33250A 33120A (Option 001) P
Counters
Universal Counter 53230A 53132A
53131A
P, T
Meters and Power Sensors
(see below for .)
Digital Multimeter 3458A P, T
Power Meter
N1914A
e
E4419A/B
N1912A
P
To Next Page
Loading...
Need help?
General
