Keysight Technologies N9040B UXA Signal Analyzer Service Guide 37
Overview
After an Instrument Repair
After an Instrument Repair
If any instrument assemblies have been repaired or replaced, perform the
related adjustments and performance verification tests. These tests are done
using the N7800A Keysight Calibration Application Software. Refer to Chapter
16, “Post-Repair Procedures” for a list of post-repair adjustments and
performance tests based on which hardware has been changed.
Information regarding the N7800A Keysight Calibration Application Software
can be found at
http://www.keysight.com/find/calibrationsoftware
and
http://cal.software.keysight.com
To Next Page
Loading...
