350 Keysight Technologies N9040B UXA Signal Analyzer Service Guide
Assembly Replacement Procedures
Tools you will need
Tools you will need
Figure 15-1 TORX Tool
Adjustments Tests after an instrument repair
Refer to Table 16-1 on page 487 for information about post-repair procedures.
If one or more instrument assemblies have been repaired or replaced, perform
the related adjustments and performance verification tests.
Description Keysight Part Number
TORX Hand Driver - Size T-8 source locally
TORX Hand Driver - Size T-10 source locally
TORX Hand Driver - Size T-20 source locally
9/16 inch nut driver source locally
1/4 inch nut driver source locally
5/16 inch open-end wrench source locally
1/4 inch open-end wrench source locally
1/4 inch socket on 4 lb torque wrench source locally
cable puller 5021-6773
To Next Page
Loading...
