Keysight Technologies N9040B UXA Signal Analyzer Service Guide 99
Instrument Messages
Event Messages
–221 Settings conflict;Function
not available while
measurement is running
Settings change is not allowed while measurement is
running. You must stop the current measurement if you wish
to change the settings.
–221 Settings conflict;function
unavailable with this EMC
Standard
–221 Settings conflict;Log
Percent Auto Step Rule does
not apply in Swept Scan
Type.
The Log Percent rule is not available when Scan Type=Swept
Scan because we are always doing linear sweep.
–221 Settings conflict;QPD + EMI
Average + RMS Average is not
allowed
User is not allowed to turn on all 3 EMI detectors together.
You must turn off one of the EMI Detectors before you turn
this on.
–221 Settings conflict;Range <0>
is turned off as total range
points > 40001
Max of Total range points is 400000. Reduce Scan Points or
increase Step Size in order to turn on that range.
–221 Settings conflict;RF Input 2
is not available above 1GHz
If the frequency range is set above 1GHz, user is not allowed
to change to RF Input 2.
–221 Settings conflict;Scan Time
& Points do not apply in
current Step/Time Control.
The Scan Time & Points are not available when Step/Time
Control is set to Step & Dwell.
–221 Settings conflict;Step Size
& Meas Time do not apply in
current Step/Time Control.
The Step Size & Meas Time are not available when
Step/Time Control is set to Scan Time&Pts.
Err# Message Verbose/Correction Information
To Next Page
Loading...
Need help?
General
