Kohler KDI 1903M Workshop Manual

9
ASSEMBLY INFORMATION
EN 136
9.
Check the tension of the belt S with the instrument
(DE
NSO BTG-2), positioning it in point P (the tensio
n
m
ust be between 200 and 230 N).
10.
If the tension values do not correspond, tighte
n
s
crews A and D, then repeat operations 7, 8, 9 an
d
10.
9.14.3 Starter Motor
Important
•
Remove the tool if still there ST_34.
1.
Fit the starter Q with the screws R on to the flange
bell S (tightening torque of 45 Nm).
Fig 9.88
9.15 Tightening torques and the use of sealants
Tab. 9.4 - * Alternatively to the capscrew replacements, with "Dri-loc"
BASE CONFIGURATION
SHORT BLOCK
Component
Thread
(mm)
Torque (Nm) Sealer
Breather room closing cover fastening capscrew (EXHAUST
SIDE)
M6x1 10
Lower crankcase fastening capscrew
M12x1.25
3 Torque
cycles
1st Cycle
40
2nd Cycle
70
3rd Cycle
120
Lower crankcase fastening capscrew M8x1.25
2 Torque
cycles
1st Cycle
20
2nd Cycle
35
Connecting rod screw M8x1
2 Torque
cycles
1st Cycle 40
2nd Cycle
85
Crankshaft gasket flange fastening capscrew
M6x1
10
Closing cover fastening capscrew 3
rd
PTO
M8x1.25 25
Loctite
2701*
Idle gear lubr. hole cap closure M14x1.5 30
Loctite
2701*

Kohler KDI 1903M Specifications

General

Brand	Kohler
Model	KDI 1903M
Category	Engine
Language	English