Kohler KDI 1903M - Page 150

11
INFORMATION ABOUT OPTIONAL
COMPONENTS
EN 150
11.4.2 Assembly
1.
Secure the bracket N using the screws M on the
cylinder head P (tightening torque at 25 Nm).
Fig 11.16
2.
Insert the screw H into the fixing hole on the
alternator L.
3.
Insert the spacer R on the screw H (between the
alternator and crankcase).
4.
Tighten the screw manually H onto the crankcase Q.
5.
Orientate the second fixing hole of the alternator L
with the hole of the bracket N, secure the alternator L
using the screw G (tightening torque at 25 Nm) onto
the bracket N and then the screw H (tightening
torque at 25 Nm).
Fig 11.17
6.
Insert the pin F in the plate slot E.
7.
Orientate the pin F with the surface S (support f
or
screw A) upwards.
8.
Secure the plate E using the screws D on the bracke
t
N (
tightening torque at 25 Nm).
Fig 11.18
9.
Insert the screw B in the plate C1 and pulley C.
10.
Manually tighten the screw B onto the pin F up to the
stop; Undo the screw B again by one turn.
NOTE: The screw B must protrude by about 32 mm (A) from
the surface of the tightening pulley C (see detail X).
11.
Install the new belt H (Fig. 11.10).
12.
Tighten the screw A onto the plate E up to the stop
on the pin F.
13.
Perform the operations from point 6 to 8 of Par.
11.3.
Fig 11.19