Kubota D1803-CR-E4 - Checking Camshaft Position Sensor; Checking Coolant Temperature Sensor; Checking Crankshaft Position Sensor

4.23 Checking crankshaft position
sensor
1. Disconnect the
sensor and check the following
items.
• Check that there is a large amount of magnetic
foreign material adhering to the sensor surface
or not.
• Check that there are interference marks of the
pulsar and the sensor or not.
• Check that there are any pulsar gear
abnormalities or not.
(1) Crankshaft position sensor
NOTE
• If the
sensor is faulty, replace the crankshaft
position sensor.
RELATED PAGE
4.31 Adjusting air gap between crankshaft position
sensor and flywheel on page 4-1
14
4.24 Checking camshaft position
sensor
1. Disconnect
the
sensor and check the following
items.
• Check that there is a large amount of magnetic
foreign material adhering to the sensor surface
or not.
• Check that there are interference marks of the
pulsar and the sensor or not.
• Check that there are any pulsar gear
abnormalities or not.
(1) Camshaft position sensor
NOTE
• If the
sensor is faulty, replace the camshaft
position sensor.
RELATED PAGE
4.32 Adjusting air gap between camshaft position
sensor and pulsar gear on page 4-
115
4.25 Checking coolant temperature
sensor
Tools required
• Circuit tester
1.
Turn the key switch “OFF”.
2. Remove the connector from the sensor side.
SERVICING
4. Checking and adjusting 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4-109
KiSC issued 12, 2018 A