Kubota D1803-CR-E4 - Flywheel Stopper

For small end bushing
A 162 mm (6.38 in.)
B 35 mm (1.4 in.)
C 27 mm (1.1 in.)
D 35 mm dia. (1.4 in. dia.)
E
27.90 to 27.95 mm dia. (1.099 to 1.100 in.
dia.)
F
25.00 to 25.01 mm dia. (0.9843 to
0.9846 in. dia.)
Material SS400
For idle gear bushing
A 175 mm (6.89 in.)
B 40 mm (1.6 in.)
C 38 mm (1.5 in.)
D 45 mm dia. (1.8 in. dia.)
E
41.90 to 41.95 mm dia. (1.650 to 1.651 in.
dia.)
F
37.950 to 37.970 mm dia. (1.4941 to
1.4948 in. dia.)
Material SS400
6. Flywheel stopper
Use for loosening and tightening the flywheel screw.
NOTE
• This
special
tool is not provided, therefore
make it by referring to the figure.
A 140 mm (5.51 in.)
B 80 mm (3.1 in.)
C 49.3 mm (1.94 in.)
D 49.3 mm (1.94 in.)
E 23.8 mm (0.937 in.)
F 23.8 mm (0.937 in.)
G 11 mm dia. (0.43 in. dia.)
H 56.5 mm (2.22 in.)
I 56.5 mm (2.22 in.)
J 8 mm (0.3 in.)
Material SS400
7. Crankshaft bearing 1
replacing tool
Use for press out and press fit the crankshaft bearing 1.
NOTE
• This special
tool is not provided, so make it
referring to the figure.
2. GENERAL
SPECIAL TOOLS
6. Flywheel stopper
2-36
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
KiSC issued 12, 2018 A