Kubota D1803-CR-E4 - Removing Cylinder Head Cover; Removing Glow Plug; Removing Injector

5.13 Removing cylinder head cover
1. Remove the cylinder head cover (1).
(1) Cylinder head cover
5.14 Removing glow plug
1. Remove the glow lead (1).
2. Remove the glow plugs (2).
(1) Glow lead (2) Glow plug
5.15 Removing injector
1. Remove the injector clamp (2).
2. Remove the injector (1) and its gasket (4).
IMPORTANT
• Do not disassemble the injector (1).
•
Do not damage the injector ID code (6).
• Do not get the injectors out of order.
• If the injectors get out of order, it is
necessary to perform injector correction
(writing the injector ID codes (6) to the
engine ECU).
• Store the injectors so they do not get any
dust in them.
(1) Injector
(2) Injector clamp
(3)
O-ring
(4) Gasket
(5) Injector clamp mounting
screw
(6) Injector ID code
4. ENGINE
SERVICING
5. Disassembling
4-122
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
KiSC issued 12, 2018 A