Kubota D1803-CR-E4 - Removing Crankshaft Oil Slinger; Removing Fan Drive Pulley; Removing Gear Case Cover; Removing Water Pump

5.24 Removing water pump
1. Remove the water pump (1).
(1) Water pump
5.25 Removing fan drive pulley
Tools required
• Flywheel stopper
•
Gear puller
• 46 mm (1.8 in.) deep socket wrench
1. Mount a flywheel stopper (1) on the flywheel.
(1) Flywheel stopper
2. Remove the
fan drive pulley mounting nut (2) with a
46 mm (1.8 in.) deep socket wrench (3).
3. Remove the fan drive pulley (4) with gear puller.
(2) Fan drive pulley mounting
nut
(3) 46 mm (1.8 in.) deep socket
wrench
(4)
Fan drive pulley
4. Remove the feather key.
5.26 Removing gear case cover
1. Remove
the
hour meter gear case cover (if
attached).
2. Remove the gear case cover (1).
(1) Gear case cover
5.27 Removing crankshaft oil slinger
1. Remove the crankshaft collar (3).
4. ENGINE
SERVICING
5. Disassembling
4-126
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
KiSC issued 12, 2018 A