Kubota D1803-CR-E4 - Installing CRS Intermediate Harness

6.41 Installing CRS intermediate harness
1. Connect the engine intermediate harness (engine side).
(1) Camshaft position (G) sensor
connector (3P)
(2) Crankshaft position (NE) sen-
sor connector (3P)
(3)
Oil pressure switch connector
(1P)
(4) Name plate
(5) Coolant temperature sensor
connector (2P)
(6) Intake throttle valve connector
(6P)
(7) Rail pressure sensor connec-
tor (3P)
(8) Fuel temperature sensor con-
nector (2P)
(9) Suction control valve (SCV)
connector (2P)
(10) Boost pressure sensor con-
nector (3P)
(11) Intake air temperature sensor
connector (2P)
(12) Resistor 120 Ω (2P)
(13) Resistor 1.1 kΩ (2P)
(14) EGR valve connector (3P)
(15) CAN connector (4P)
(16) CAN connector (4P)
(17) Engine intermediate connector
(18) Engine joint connector 4 (8P)
(19) Engine joint connector 3 (8P)
(20) Engine joint connector 2 (10P)
(21) Engine joint connector 1 (6P)
(a)
to (j)
Clamp
2. Connect the injector intermediate harness (engine side).
(4) Name plate
(22) Injector connector (10P)
(23) Injector intermediate connec-
tor (12P)
(k) Clamp
SERVICING
6. Assembling 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4-159
KiSC issued 12, 2018 A