Kubota D1803-CR-E4 - Removing Bearing Case Cover; Removing Crankshaft (for 3 Cylinders); Removing Flywheel Housing

4. Remove the flywheel (3).
(3) Flywheel (4) Flywheel guide screw
5.38 Removing flywheel housing
1. Remove the flywheel housing (1).
(1) Flywheel housing
5.39 Removing bearing case cover
NOTE
• Before
disassembling,
check the side clearance
of crankshaft. Also check it after reassembling.
1. Remove the inner mounting screws of bearing case
cover (1).
2. Remove the external mounting screws of bearing
case cover (2).
NOTE
• The length
that inner mounting screws of
bearing case cover (1) and external
mounting screws of bearing case cover (2)
are different.
(1) Inner mounting screw of
bearing case cover
(2) External mounting screw of
bearing case cover
3. Remove the bearing case cover (3).
(3) Bearing case cover
5.40 Removing crankshaft (for 3
cylinders)
NOTE
• Before you disassemble, measure the side
clearance of crankshaft. Measure it when you
assemble again.
• This topic is used for only 3 cylinders engine
(D1803-CR-E4, -TE4, -TIE4).
SERVICING
5. Disassembling 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4-131
KiSC issued 12, 2018 A