4. Install
the fan drive pulley mounting nut (4) and
tighten
to specified torque with a 46 mm (1.8 in.)
deep socket wrench (3).
NOTE
• Apply grease to the splines of coupling.
T
ightening tor-
que
Fan drive pulley
mounting nut (4)
167 to 205 N⋅m
17.1 to 20.9 kgf⋅m
124 to 151 lbf⋅ft
(2) Fan drive pulley
(3)
46 mm (1.8 in.) deep socket
wrench
(4)
Fan drive pulley mounting
nut
6.21 Installing water pump
1. Install the water pump (1).
NOTE
• Take care not to forget mounting the O-ring
and not to let it out of position.
(1) Water pump
6.22 Installing oil cooler
1. Install the oil cooler (3) and water hose (1), (2).
2. Install
the
oil cooler joint screw (4) and tighten to
the specified tightening torque.
Tightening tor-
que
Oil cooler joint
screw (4)
39.2 to 49.0 N⋅m
4.00 to 4.99 kgf⋅m
29.0 to 36.1 lbf⋅ft
(1) Water hose
(2) W
ater hose
(3) Oil cooler
(4) Oil cooler joint screw
SERVICING
6. Assembling 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
To Next Page
Loading...
