Kubota D1803-CR-E4 - Installing Cylinder Head Cover; Installing Sensors

2. Install the glow lead (3).
Tightening tor-
que
Glow lead mount-
ing nut
0.980 to 1.77 N⋅m
0.100 to 0.180 kgf⋅m
0.723 to 1.30 lbf⋅ft
(1) Glow plug (3) Glow lead
6.32 Installing cylinder head cover
NOTE
• Replace the gasket with a new one.
1. Install the cylinder head cover (1) and tighten to the
specified torque.
Tightening tor-
que
Cylinder head cov-
er screw
6.86 to 11.3 N⋅m
0.700 to 1.15 kgf⋅m
5.06 to 8.33 lbf⋅ft
(1) Cylinder head cover
6.33 Installing sensors
IMPORTANT
•
If you drop the sensor
, do not reuse it.
NOTE
• Replace the gasket with a new one.
•
Replace the O-ring with a new one.
1. Install the coolant temperature sensor (1) and
tighten to the specified torque.
T
ightening tor-
que
Coolant tempera-
ture sensor (1)
15.7 to 19.6 N⋅m
1.60 to 1.99 kgf⋅m
11.6 to 14.4 lbf⋅
ft
(1) Coolant temperature sensor
2. Install the camshaft position sensor (2).
3. T
ighten
the camshaft position sensor mounting
screw (3) to the specified torque.
NOTE
• If replace
the camshaft position sensor,
measure the air gap between camshaft
position sensor and pulsar gear.
Air gap
Service specifi-
cation
0.20 to 1.3 mm
0.0079 to 0.051 in.
Tightening tor-
que
Camshaft position
sensor mounting
screw (3)
9.81 to 11.3 N⋅m
1.00 to 1.15 kgf⋅m
7.24 to 8.33 lbf⋅ft
(2) Camshaft position sensor (3) Camshaft position sensor
mounting screw
4. Install the crankshaft position sensor (4).
SERVICING
6. Assembling 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4-153
KiSC issued 12, 2018 A