Kubota D1803-CR-E4 - Removing Camshaft with Cam Gear; Removing Crank Gear; Removing Oil Pump

5.30 Removing camshaft with cam
gear
1. Remove the
camshaft set screws and draw out the
camshaft (1) with cam gear (2).
(1) Camshaft (2) Cam gear
5.31 Removing oil pump
Tools required
• Gear puller
1.
Remove the oil pump drive gear 1 mounting nut (1).
(1) Oil pump drive gear 1
mounting nut
2. Pull
out the oil pump drive gear 1 (2) with a gear
puller (3).
(2) Oil pump drive gear 1 (3) Gear puller
3. Remove the oil pump (4).
(4) Oil pump
5.32 Removing crank gear
Tools required
• Gear puller
1.
Remove the crank gear (2) with a gear puller (1).
2. Remove the feather key.
3. Remove the idle gear shaft (3).
(1) Gear puller
(2)
Crank gear
(3)
Idle gear shaft
4. ENGINE
SERVICING
5. Disassembling
4-128
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
KiSC issued 12, 2018 A