3. Install
the bearing retainer (4) to the front bracket
(3).
(3) Front bracket (4) Bearing retainer
4. Install the rotor (1) to the front bracket (3).
(1) Rotor (3) Front bracket
5. Lightly secure
the rotor with a vise to prevent
damage.
6. Install the pulley and tighten the pulley nut to the
specified torque.
Tightening torque Pulley nut
58.4 to 78.9 N⋅m
5.95 to 8.05 kgf⋅m
43.1 to 58.2 lbf⋅ft
7. Fit the brush with its sliding face in the clockwise
direction when viewed from front.
IMPORTANT
• Be sure
to keep the 2 brushes deep in the
brush holder.
Otherwise the rotor and the rear section can
not be fitted into the position.
8. Push the brushes into place using a 4 mm hex.
wrench.
9. Keep the brushes from popping out using a pin-
pointed punch.
10. Align the mark line (5) of the front bracket with that
of the rear bracket.
(5) Mark line
11. Tighten the 4 screws.
SERVICING
6. Assembling 4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
To Next Page
Loading...
