12 Repair (continued)
163 of 206
BA KR 6, 16 F, KR C4 12.10.07 en
12.2 Bonding instructions
Information!
When sealants, adhesives and locking agents are used, the manufacturer’ s directions
must be strictly observed. This also applies to the cleaning of open sealing, locking and
adhesion joints where the parts to be joined are to be used again.
D Instructions for bonding components
(1) Wash the components with cleaning agent and blow them dry.
(2) Wash the components with cleaning agent again and dry them with a lint--free cloth.
(3) Apply a thin layer of adhesive to one side of the joint, assemble the components and
insert the screws.
Notice!
The screw thread is to be lightly greased in order to prevent the screws from be-
coming stuck.
(4) Tighten the screws with the specified torque.
(5) Remove any excess adhesive which has emerged from the joint.
To Next Page
Loading...
