2PV/2PW-2
1-5-60
(Detach the high voltage PWB (HVU PWB).)
23. Remove the screw.
24. Release four hooks of the upside of the
PWB circled in the figure and slant the
upside of the high voltage PWB like
opening it, and then remove the FFC.
25. After surely slanting the high voltage
PWB till ninety degree, pull it out toward
the machine right side.
*: If trying to pull out the PWB on the way of
slanting till ninety degree, the hooks
securing the PWB’s low side may dam-
age. (The hooks are circled at the figure.)
Figure 1-5-95
Hook A
Hook A
Hook A
Hook A
Hooks B
Hooks B
FFC
High voltage PWB
Screw
To Next Page
Loading...
