2PV/2PW
1-3-30
U250 Setting the maintenance cycle
Description
Displays, clears and changes the maintenance cycle.
Purpose
To check and change the maintenance cycle.
Method
1. Press the start key. The currently set maintenance cycle is displayed.
Setting
1. Select [M.Cnt A] using the cursor up/down keys.
2. Change the setting using the cursor left/right keys or numeric keys.
3. Press the start key. The value is set.
Clearing
1. Select [Clear] using the cursor up/down keys.
2. Press the start key. The count is cleared.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Item No. Description
Description Setting range Initial setting
Maintenance cycle 0 to 9999999 200000
To Next Page
Loading...
