5-32
Operation on the Machine > Handling Destination
Confirmation Screen of Destinations
When selecting [On] for Destination Check before Send, the confirmation screen of destinations appears after
pressing the [Start] key.
DestinationCheck (page 8-46)
Follow the steps below to confirm the destinations.
1 Confirm all destination.
To show the detailed information of the destination, select the destination and [OK] key > [] [] key > [Detail] >
[OK] key
To delete the destination, select the destination you want to delete and [OK] key >
[] [] key > [Delete] > [OK] key
> [Yes]
The destination is deleted.
2 Select [Next].
Recall
Recall is a function allowing you to send the last entered destination once again. When you want to send the
image to the same destination, select the [Address Recall/Pause] key, and you can call the destination you sent
on the destination list.
1 Select the [Address Recall/Pause] key.
The destination you sent is displayed on the destination list.
2 Press the [Start] key.
Sending starts.
Be sure to confirm all destination by displaying them on the message display. You cannot select
[Next] unless you have confirmed all destination.
When the last sending included FAX, computers and E-mail destinations, they are also displayed. If
necessary, add or delete the destination.
• When [On] is selected in "Check beforeSend", a destination confirmation screen is displayed when
you press the [Start] key.
Confirmation Screen of Destinations (page 5-32)
• Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
To Next Page
Loading...
