2-29
Installing and Setting up the Machine > Energy Saver function
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To change the preset sleep time, refer to the following:
Sleep Timer (page 8-35)
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card
cannot be recognized.
For more information on Sleep Rules settings, refer to the following:
Sleep Rules (models for Europe) (page 8-35)
Sleep Level (Energy Saver and Quick Recovery) (models
except for Europe)
For sleep level, you can toggle between the following two modes: Energy Saver mode and Quick Recovery mode.
The default setting is Energy Saver mode.
Energy Saver mode reduces power consumption even more than Quick Recovery mode, and allows Sleep Mode
to be set separately for each function. The ID card cannot be recognized.
To resume, select the [Energy Saver] key on the operation panel. If print data is received during Sleep, the
machine automatically wakes up and starts printing.
For more information on Sleep Level settings, refer to the following:
Sleep Level (models except for Europe) (page 8-35)
Weekly Timer Settings
Set the machine to automatically sleep and wake up at times specified for each day.
For more information on Weekly Timer Settings, refer to the following:
Letterhead (page 8-33)
Power Off Rule (models for Europe)
If the machine is not used while in sleep mode, the power automatically turns off. The Power Off Rule is used to
stop the power from automatically turning off.
The default preset time is 3 days.
For more information on Power Off Rule settings, refer to the following:
Power Off Rule (models for Europe) (page 8-36)
If the optional Network Interface Kit is installed, this function will not be displayed.
To Next Page
Loading...
