Kyocera ECOSYS MA4500x

6-24
Using Various Functions > Functions
EmailEncryptedTX
Sends encrypted E-mail using the electronic certificate.
Encryption secures the document transmission.
(Value: [Off] / [On])
DigitalSignature
Add a digital signature to the email, using the electronic certificate.
By adding a digital signature to an email, you can confirm the identity of the destination and detect tampering
during transmission.
(Value: [Off] / [On])
Command Center RXConfiguring S/MIME
To send encrypted email and use the use the digital signature function for email, the following settings must be
configured in advance from the Command Center RX.
1
Accessing Command Center RX
2
Register the device certificate which is used for S/MIME.
1 From the [Network Settings] menu, click [Certificates] .
2 Click [Address Book] of " Device Certificate" (1 to 5) to create or import the device certificate.
3 Click [Restart/Reset] > [Restart entire device] to restart the device.
3
Configure the protocol settings
1 From the [Function Settings] menu, click [Protocols] .
2 Set [Send Protocols] and [S/MIME] of " Send Protocol" to [On] .
NOTE
To use this function, configure the certificate, protocol and email function in the Command Center RX.
Command Center RX (page 2-49)
NOTE
To use this function, configure the certificate, protocol and email function in the Command Center RX.
Command Center RX (page 2-49)
Accessing Command Center RX (page 2-50)
Command Center RX User Guide