9-21
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
NW User Property (Obtain Network User Property)
Set the required information to obtain the network user property from the LDAP server. The user name and E-
mail address obtained with this setting is shown in the user information, the status confirmation screen, and the
header of E-mail.
1
Display the screen.
1 [System Menu/Counter] key > [ ] [ ] key > [User/Job Account] > [OK] key
2 [] [] key > [User Login Set.] > [OK] key
2
Configure the settings.
[] [] key > [NW User Property] > [OK] key > [ ] [ ] key > [Off] or [On] > [OK] key
• To obtain the network user property from the LDAP server, [Netwk Authentic.] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Settings".
Enabling User Login Administration (page 9-3)
ProtocolSettings (page 8-14)
• Setting to obtain network user information is performed from the operation panel. The details of the
information to be obtained should be set with Command Center RX.
Command Center RX User Guide
If the User Authentication screen appears, log in with a user who has the privilege to configure this
setting. If you do not know your login User Name or Password, please contact your Administrator.
To Next Page
Loading...
