5-13
Operation on the Machine > Sending Document via E-mail
Sending Document via E-mail
1
Select the [Send] key.
2
Place the originals.
3
In the basic screen for sending, select [] [] key > [E-mail] > [OK] key
4
Enter destination E-mail address > [OK] key
Up to 256 characters can be entered.
To send to multiple destinations, select the [Confirm/Add Destination] key. You can send to as many as
100 destinations at once.
Destinations can be changed later.
• When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (page 8-21)
• Before sending a scanned document by e-mail, it is necessary to configure SMTP and e-mail sending from
Command Center
RX.
E-mail Settings (page 2-53)
Loading Originals (page 5-2)
Character Entry Method (page 11-9)
Checking and Editing Destinations (page 5-31)
If [Prohibit] is set to “Broadcast”, multiple destinations cannot be entered.
Broadcast (page 8-46)
To Next Page
Loading...
