Labconco Logic+ A2 User Manual

133
UV Lamp Socket Replacement
If a lamp socket for the UV lamp is damaged and needs to be replaced, follow these
instructions.
1. Start the cabinet blower and let it operate for 5 minutes.
2. Raise the sash to its full open position.
3. Thoroughly surface decontaminate the UV lamp and the work area of the
cabinet.
4. Remove the UV lamp by rotating it 90 degrees, then lift it straight up to free it
from the sockets.
5. Use a #1 Phillips screwdriver to remove the screw by the defective socket.
6. Rotate the defective socket and pull it out of the cutout in the baffle.
7. Disconnect the two wire connections, and treat the defective socket as
contaminated biohazardous waste when disposing of it.
8. Install the new socket.

Labconco Logic+ A2 Specifications

General

Brand	Labconco
Model	Logic+ A2
Category	Laboratory Equipment
Language	English