Labconco Logic+ A2 User Manual

97
12: Advanced Service Procedures
This section provides instructions to perform advanced service procedures on the
biosafety cabinet. Such procedures include changing HEPA filters, adjusting the sash or
sash position sensors, replacing LED or UV lamps, and more.
Tools
Required
 #2 Phillips screwdriver or #2 Phillips bit (4 inches long minimum)
 Ratchet with extension
 Sockets
o 5/16-inch
o 3/8-inch
o 7/16-inch
o 1/2-inch
 3/8-inch nut driver
 1/2-inch nut driver
Optional
 Cordless screwdriver/drill
 Cordless ratchet (low profile right angle impact driver)
 Pliers (standard and needle nose)
 #10-24 Tap
 5/16-18 Tap
If a cordless screwdriver or drill is used to drive screws, reduce the torque setting to a
minimum to avoid stripping the screw head.

Labconco Logic+ A2 Specifications

General

Brand	Labconco
Model	Logic+ A2
Category	Laboratory Equipment
Language	English