Lenze L-force 8400 BaseLine D - Page 226

8400 BaseLine D | Software Manual
Index
226 L Firmware 03.00 - DMS EN 5.0 - 07/2009
R
Ramp rounding main setpoint (C00134) 189
Rated device current (C00098) 187
Rated motor current (C00088) 185
Rated motor frequency (C00089) 185
Rated motor power (C00081) 184
Rated motor speed (C00087) 185
Rated motor torque (C00097) 187
Rated motor voltage (C00090) 186
Reduced brake chopper threshold (C00174) 197
Reset of error message 131
Resp. to brake resist. overtemp. (C00574) 206
Resp. to DC bus undervoltage (C00600) 207
Resp. to device overload (Ixt) (C00604) 208
Resp. to LS_SetError_x (C00581) 207
Resp. to mains phase failure (C00565) 206
Resp. to motor overload (I²xt) (C00606) 208
Resp. to open circuit AINx (C00598) 207
S
Safety instructions 11
Schnittstellenbeschreibung_TA_NCtrl 142
Select control mode (C00007) 177
Select motor control (C00006) 176
Setting the error response 128
Short overview of error messages 132
Slip compensation (C00021) 179
Speed limitation (C00909) 217
S-ramp time PT1 (C00182) 198
Status of last device command (C00003) 175
Status word (C00150) 192
Status word 2 (C00155) 193
Switching cycles (C00177) 197
Switching frequency (C00018) 179
Switching frequency reduction (temp.) (C00144) 191
System error messages 129
T
Technology applications 135
Thermal motor load (I²xt) (C00066) 184
Ti Imax controller (C00074) 184
Time of error (C00169) 196
Torque (C00056) 183
U
User menu (C00517) 206
V
VFC
V/f base frequency (C00015)
178
Vmin boost (C00016) 178
Vp Imax controller (C00073) 184