User Guide
Leviton D4200 LCD Ver 2.0 Architectural Lighting Controller Page 48 of 80
When operating the unit, the Master Up and
Down buttons uses the last preset/scene’s zone
exclude list as defined in this section.
Setting the Date and Time - MANDATORY
The date and time are important for the scheduler to operate
properly. The date must be set correctly if Astronomical Time Events
are used.
To set the date and time:
Step 1: Press the Menu/Cancel button.
Step 2: Press the Up and Down buttons until SET
DATE/TIME? flashes on the LCD display.
Step 3: Press the Select/Save button.
The
HOUR
field flashes.
The date and time are displayed in the following format:
Step 4: Press the Left and Right buttons to select a
field to edit,
or proceed to the next step until you want to change the
current field.
Step 5: Press the Up and Down buttons to change the
value.
Step 6: Press the Select/Save button to save a value.
Step 7: Press the Menu/Cancel button to exit this menu.
Setting the date and time will set date and time on all
other stations on the same lighting control network
(using the Luma-Net™ data protocol).
03:04P TUE
12H 01/25/2001
Day of weekTime
Format (12/24)
Date (M/D/Y)
To Next Page
Loading...
