Leviton D4200 - Sequencer

User Guide
Leviton D4200 LCD Ver 2.0 Architectural Lighting Controller Page 43 of 80
Step 16: Press the Up and Down buttons to select
another Event and repeat steps 5 -15 until all Events have
been programmed.
Step 17: Press the Menu/Cancel button if you are finished
editing events.
You return to the VIEW SCHEDULE? menu command.
The LCD display times out and returns to MANUAL MODE
if no changes are made for 60 seconds.
Enabling the Scheduler
To enable or disable the scheduler:
Step 1: Press the Menu/Cancel button.
Step 2: Press the Up and Down buttons until
SCHEDULER= flashes on the LCD display.
Step 3: Press the Select/Save button.
The current status of the scheduler flashes.
Step 4: Press the Up and Down buttons to change the
value.
Step 5: Press the Select/Save button to save the value.
Step 6: Press the Menu/Cancel button to exit this menu.
Sequencer
The sequencer causes Scenes to be activated in a timed sequence.
The sequence may be programmed to run once or continuously in a
loop. The sequence can be activated manually (preset/scene buttons)
or by the event timer (scheduler). The sequence can be sub-divided
into groups of events simply by the use of commands that start it
(GOTO a specific step). There is a table provided in Appendix A to
help you set up the sequencer schedule.