Leviton D4200 - Setting the Station Lock Code

User Guide
Leviton D4200 LCD Ver 2.0 Architectural Lighting Controller Page 51 of 80
Step 4: Press the Up and Down buttons to change the
value.
Note: Press Clear to reset the value to 000 .
Step 5: Press the Select/Save button to save the value.
SET RECORD LOCK?
flashes again.
Step 6: Press the Menu/Cancel button to exit this menu.
Setting the Station Lock Code
The Station Lock Code must be a number between 000 and 999. The
default code is 000.
Shortcut
: Use a code number between 000 and 999, as
the Preset - Scene buttons 1 to 8 and MAX (9) and OFF
(0) can be used to enter the code in directly.
To set the station lock code:
Step 1: Press the Menu/Cancel button.
Step 2: Press the Up and Down buttons until SET
STATION LOCK flashes on the LCD display.
Step 3: Press the Select/Save button.
The CODE Field flashes
Step 4: Press the Up and Down buttons to change the
value.
Press Clear to reset the value to 000 .
Step 5: Press the Select/Save button to save the value.
Step 6: SET STATION LOCK? flashes again.
Step 7: Press the Menu/Cancel button to exit this menu.
Enabling the Record Lock
Be sure to set the Record Lock code before enabling the
Record Lock.