Windows Software Reference (Single Chamber Mode)
8-3
Click here to
open the list of variables
that can be displayed...
or double-click inside the field to open the list.
This symbol indicates the GPS
receiver has acquired a valid
signal
The Main window displays selected data variables on the right side of the window,
as well as the progress of the current measurement and the status of various
LI-8100A parameters. You can change the variables that you want to monitor,
displayed on the right side of the window, by clicking on the dots next to any
variable and selecting a different one from the pop-up menu (above). There are also
five menus used to configure the LI-8100A, perform zero and span calibrations,
and set up the parameters for recording data.
NOTE: You can also double-click inside the data fields to open the pop-up menu,
and then double-click on the desired variable to make it active.
Using the Toolbar
The toolbar in the Main window contains shortcuts for some of the commonly used
menu items:
To Next Page
Loading...
